Close

A note on cookies

We use cookies to improve your experience of our website. Privacy Policy

Queen Mary University of LondonQueen Mary University of London
Research menu

School of Engineering and Materials Science
Research Student Awards

PhD Thesis: Experimental investigation of condensation heat transfer in microchannels.

Author: SU, Q

Year: 2007

Supervisor(s): John Rose

The thesis describes experiments aimed at measurement of heat-transfer coefficients for condensation in a multi micro channel tube. Experiments were performed with steam and R113, fluids chosen to cover a wide range of thermophysical properties, in particular, surface tension which plays an important role during condensation in small, non-circular channels.

The aluminium extruded condenser tube used had cooled length 748 mm and 13 parallel channels each with height 1.38 mm and width 1.41 mm. The upper and lower outer surfaces were cooled separately by water in counter flow in channels above and below the test tube. The mass flow rates in the two channels were adjusted to be the same. Coolant temperatures were measured at 17 positions along each of the coolant channels as well as at inlet and exit. An accurate direct measurement of the overall inlet-to-outlet coolant temperature difference was also measured directly with a 10-junction thermopile for each of the two coolant streams with junctions downstream of mixers. Temperatures of the condenser tube wall were measured at 10 positions on each of the upper and lower surfaces using embedded thermocouples. Temperatures and pressures of the vapour were measured in chambers at the inlet and outlet of vapour stream. Pressures were also measured in the condenser channels just upstream and just downstream of the cooled section.

Data have been obtained for cases where the vapour was saturated (for both steam and R113) at inlet. Runs were made for complete and incomplete condensation within the tube.